DDW80/40-HORIZONTAL DIRECTIONAL DRILL

Negotiable
China
No.6, Huoxing Fifth Street, Huo County Development Area, Tongzhou District, Beijing, China
+86 158 0128 6508
Online Contact
Favorite
Product Introduction

ENGINE

Broad opening of the engine and hydraulic system for a most easy service and check-up during the operation of any tough jobs by the operator.

FLUID PUMP

The most strong and enough flow and pressure of mud pump gives the machine and drill a fast and fluent daily work no matter in the soil condition or hard land ground.

PIPE LOADER

The new design of one rod pipe loader make the job more easy and more safe for the workman during any pipe replacement and installation.

ROTARY & CARRIAGE

The most powerful rotation and thrust system gives the machine fast drill without any stop at the front of hard ground challenge.

Product Parameters
Dimensions
Length/Width/Height 9900*2300*2700 mm
Entry angle 14°
Machine weight 20 ton
Structure
Structure Box welded frame, Self-propelled on track crawler
Travel Self-propelled on track crawler
Travel speed 0-2.5 km/h, forward & reverse
Track Steel type with rubber pad
Track plate width 400 mm
Rear stabilizer 2
Wrench assembly
Type Clamp jaw
Max breakout torque 100000 Nm
Max makeup force 460 KN
Clamp range 127 -168 mm
Operator station
Cabin Full closed, climate control with A/C
Rotation 0-900
Control system Electronic & hyd
Operation controls Joystick 2
Mast
Fluid channel Yes
Transmission type Rack & pinion
Hose carrier Full length of chain type
Setup mode Double cylinder
Pipe loader
Type One rod type pipe loader
Engine
Make Cummins
Rated power 264 KW
Rated speed 2200 rpm
Fuel tank capacity 400 L
Rotary drive
Rotary torque 40000 N.M
Rotary speed 140
Transmission Gear box
Rotary shaft NC38
Crane
Lifting capacity 2 ton
Control Out doors
Hydraulic system
Max pressure (rotary & carriage) 40 Mpa
Max pressure (control sys.) 34 Mpa
Hydraulic tank capacity 750 L
Carriage
Maximum thrust/pullback force 800 KN
Max travel speed 46 m/min
Max travel distance 5.3 m
Mud pump
Type On board
Volume 950 L/min
Maximum pressure 10 Mpa
Undercarrage
   
Stake down
Anchoring type Manual anchoring
Hole nos. 3
Drill pipe
Type Φ102*4500 mm
Thread NC38
Tools
Back reamer Diameter 330, 430, 530, 630, 730, 820, 920, 1050 mm
Transmitter
   

※ Closed cabin with A/C, on board crane, hydraulic anchor system, automatic pipeloader etc, can be optional equipment available at customer's request! ※